Asrock FM2A75 Pro4-M review
A great budget FM2 motherboard with plenty of overclocking options
Specifications
FM2, microATX, AMD A75 FCH chipset, supports: AMD 2nd gen A-series
This mid-range FM2 motherboard uses AMD’s A75 chipset and supports the second-generation A-series of processors. Its M suffix denotes it’s the microATX version of its larger cousin, the Pro4, but there’s still plenty of features here to suit all types of users.
With five SATA3 ports located in the front corner, there’s no need to compromise on speed and you can happily get the most out of a fast SSD, while leaving enough ports free for tons of hard disks. USB support is equally as good, with two USB3 and four USB ports on the back panel, and one USB3 and two USB headers for further expansion. There is also one eSATA3 port, five 3.5mm audio jacks for 7.1 analogue sound and a S/PDIF output, as well as a Gigabit Ethernet and a PS/2 port.
There’s the usual VGA, DVI-D and HDMI graphics outputs, so you can use the processor’s on-chip GPU. Asrock also states that all three outputs can be used at the same time, so you can run up to three monitors from the processor’s graphics chip, which means you may not need a discrete graphics card at all.
There’s a decent amount of room for expansion, too, including four DDR3 DIMM memory slots for a maximum of 64GB of RAM that can run up to speeds of 2,600MHz when overclocked. There are also two PCI-E x16 slots that can be used in CrossfireX mode with two graphics cards, Crossfire X and Dual Graphics mode, but only one of these will run at the full bandwidth, with the other running at x4. Elsewhere, there’s one PCI slot and one PCI-E x1 slot, although the latter will get blocked if you install a graphics card.
The FM2A75 Pro4-M’s performance was more or less spot-on in our benchmark tests, as our AMD A10-5800K processor and 4GB of 1600MHz DDR3 scored 63 overall. We’ve seen faster scores for this processor, but this is still roughly what we’d expect to see from an A10-5800K. Overclocking is easy, too, as its UEFI BIOS is very easy to navigate.
Asrock’s FM2A75 Pro4-M is a great micro-ATX motherboard with a wide range of features, but there’s very little to distinguish it from the similarly-priced and budget-buy winning Gigabyte F2A85XM-D3H. We much prefer Asrock’s BIOS interface, but ultimately it’s just not as good a deal as Gigabyte’s A85X-based board. Still, if you can find this motherboard cheaper elsewhere, it’s still a great choice.
Basic Specifications | |
---|---|
Rating | **** |
Processor socket | FM2 |
Form factor | microATX |
Size | 244x244mm |
Processor support | AMD 2nd gen A-series |
Processor external bus | 100MHz (HyperTransport) |
Chipset north bridge | AMD A75 FCH |
Chipset south bridge | AMD A75 FCH |
Passively-cooled north bridge | yes |
Integrated graphics | Yes |
Supported memory type | DDR3 |
Maximum memory speed | PC3-20800 |
Memory slots | 4 |
Maximum memory | 64GB |
Dual-channel support | yes |
Buying Information | |
Price | £58 |
Supplier | http://www.kikatek.co.uk |
Details | www.asrock.com |
Internal Ports | |
Power connectors | 1x 24-pin ATX, 1x 8-pin ATX |
PCI-E x16 slots | 2 |
Dual graphics architecture | CrossFireX |
PCI-E x4 slots | 0 |
PCI-E x1 slots | 1 |
PCI slots | 1 |
Fan headers | 4 |
Floppy ports | 0 |
IDE ports | 0 |
Serial ATA ports | 0 |
RAID chipset (max disks) | AMD A75 (5x SATA III, RAID 0, 1, 10) |
Features | |
Wired network ports | 1x 10/100/1000 |
Sound (ports) | Realtek ALC892 (5x analogue out, optical S/PDIF) |
USB2 ports / headers | 6/4 |
Firewire ports / headers | 0/0 |
Legacy ports | PS/2 |
Other ports | VGA, DVI, HDMI, eSATA |
Cables included | 2x SATA |
Brackets included | none |
Software included | none |
Setup and Overclocking | |
Voltage adjustment | CPU/RAM/Chipset |
CPU clock max adjustment | 6,300MHz |